TopMeter

SCPI Command :

PROBe<*>:SETup:OFFSet:TOPMeter

Commands in total: 1
Subgroups: 0
Direct child commands: 1

set(probe=Probe.Default) → None[source]

# PROBe<*>:SETup:OFFSet:TOPMeter
driver.probe.setup.offset.topMeter.set(probe = repcap.Probe.Default)

Sets the measured R&S ProbeMeter value as offset. Thus, the value is considered in measurements.

Parameters:: probe – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)

set_and_wait(probe=Probe.Default, opc_timeout_ms: int = -1) → None[source]