Range

SCPI Command :

TRIGger:EVENt<*>:WINDow:RANGe
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(evnt=Evnt.Default) → TriggerWinRangeMode[source]
# TRIGger:EVENt<*>:WINDow:RANGe
value: enums.TriggerWinRangeMode = driver.trigger.event.window.range.get(evnt = repcap.Evnt.Default)

Selects how the signal run is compared with the window.

Parameters:

evnt – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Event’)

Returns:

range_mode: ENTer | EXIT | WITHin | OUTSide

  • ENTer: Triggers when the signal crosses the upper or lower level and thus enters the window made up of these two levels.

  • EXIT: Triggers when the signal leaves the window.

  • WITHin: Triggers if the signal stays between the upper and lower level for a specified time. The time is defined with TRIGger:EVENtev:WINDow:TIME.

  • OUTSide: Triggers if the signal stays above the upper level or below the lower level for a specified time. The time is defined with TRIGger:EVENtev:WINDow:TIME.

set(range_mode: TriggerWinRangeMode, evnt=Evnt.Default) → None[source]
# TRIGger:EVENt<*>:WINDow:RANGe
driver.trigger.event.window.range.set(range_mode = enums.TriggerWinRangeMode.ENTer, evnt = repcap.Evnt.Default)

Selects how the signal run is compared with the window.

Parameters:

  • range_mode –

    ENTer | EXIT | WITHin | OUTSide

    • ENTer: Triggers when the signal crosses the upper or lower level and thus enters the window made up of these two levels.

    • EXIT: Triggers when the signal leaves the window.

    • WITHin: Triggers if the signal stays between the upper and lower level for a specified time. The time is defined with TRIGger:EVENtev:WINDow:TIME.

    • OUTSide: Triggers if the signal stays above the upper level or below the lower level for a specified time. The time is defined with TRIGger:EVENtev:WINDow:TIME.

  • evnt – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Event’)